Expedition 2WD V8-5.4L (2009)
Removal
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent
accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
instruction may result in serious personal injury.
1. Drain the cooling system.
2. Remove the generator.
3. Disconnect the quick connect couplings and remove the crankcase vent tube.
4. Loosen the clamp and remove the bolt and the air intake resonator assembly.
5. Remove the 3 bolts and the Throttle Body (TB)-to-Air Cleaner (ACL) outlet pipe adapter.
6. Disconnect the quick connect couplings and remove the PCV tube.
7. Disconnect the fuel supply tube quick connect coupling.
8. Disconnect the Evaporative Emission (EVAP) electrical connector and the EVAP tube quick connect coupling from the EVAP canister purge
valve.
9. Disconnect the upper radiator hose from the thermostat housing.
10. Disconnect the heater coolant hose from the coolant crossover manifold assembly.
11. Disconnect the 8 fuel injector electrical connectors.
