Expedition 2WD V8-5.4L (2009)
4. Using the Slide Hammer and the Crankshaft Rear Oil Seal Remover, remove and discard the crankshaft rear seal.
Installation
1. NOTE: Lubricate the crankshaft rear seal with clean engine oil prior to installation.
Using the Crankshaft Rear Oil Seal Installers, install a new crankshaft rear seal.
2. NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
Using the Crankshaft Rear Oil Seal Installers and the Crankshaft Rear Oil Slinger Installer, install a new crankshaft oil slinger.
3. Install the flexplate and tighten the 8 bolts in the sequence shown.
-
Tighten to 80 Nm (59 lb-ft).
