Expedition 2WD V8-5.4L (2009)
4. NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTICE: Only use hand tools to remove the camshaft phaser and sprocket assembly or damage may occur to the camshaft or camshaft
phaser and sprocket.
NOTE: LH shown, RH similar.
Using the Cam Phaser Locking Tool, tighten the LH and RH camshaft phaser and sprocket bolts in 2 stages.
-
Stage 1: Tighten to 40 Nm (30 lb-ft).
-
Stage 2: Tighten an additional 90 degrees.
5. Position the crankshaft with the Crankshaft Holding Tool, then remove the tool.
6. NOTICE: Timing chain procedures must be followed exactly or damage to valves and pistons will result.
NOTICE: Prior to installation, inspect the tensioner-sealing bead for seal integrity. If cracks, tears, separation from the tensioner body or
permanent compression of the seal bead is observed, install a new tensioner or engine damage may occur.
Compress the tensioner plunger, using a vise.
7. Install a retaining clip on the tensioner to hold the plunger in during installation.
