Expedition 2WD V8-5.4L (2009)
10. Install the RH C-pillar trim panel and attach the rear door weatherstrip.
11. Install the passenger C-pillar trim panel nut and cover.
12. Install the RH second row safety belt retractor D-ring and bolt.
-
Tighten to 40 Nm (30 lb-ft).
13. Attach the RH second row safety belt retractor D-ring cover.
-
Verify the safety belt retractor operates without excessive effort or binding.
-
Extract and retract the safety belt between the full extension and stowed positions.
-
If excessive effort or binding is present, install a new safety belt buckle retractor and tongue assembly as necessary. For additional
information, refer to Seat Belt Systems.
14. Connect the passenger seat side air bag module electrical connector and install the passenger front seat cushion panel shield.
