Expedition 2WD V8-5.4L (2009)
Brake Light Switch: Service and Repair
Stoplamp Switch
Removal
1. Disconnect the stoplamp switch electrical connector.
2. NOTE: The stoplamp switch will be difficult to remove if the switch plunger is not depressed. A slight rearward force should be adequate to
depress the plunger.
With a light force (approximately 1-4 N [1-3 lb]), pull rearward on the brake pedal, rotate the stoplamp switch 45 degrees clockwise and remove
the stoplamp switch.
Installation
NOTICE: It is very important to not press, pull or touch the brake pedal assembly during the installation of the stoplamp switch. Failure to
follow these instructions may damage the stoplamp switch.
1. Without movement to the brake pedal assembly, install the stoplamp switch and rotate 45 degrees counterclockwise.
2. Connect the stoplamp switch electrical connector.
