Expedition 2WD V8-5.4L (2009)
Suspension/Steering/Power Steering/Power Steering Pump/Service and Repair/Power Steering Pump Pulley.
2. Remove the 2 bolts and the oil drip shield.
-
To install, tighten to 7 Nm (62 lb-in).
3. Disconnect the power steering pressure line-to-power steering pump fitting.
-
To install, tighten to 65 Nm (48 lb-ft).
4. Disconnect the Power Steering Pressure (PSP) switch electrical connector.
5. Remove the power steering pressure line bracket-to-crossmember bolt.
-
To install, tighten to 7 Nm (62 lb-in).
6. Remove the power steering pressure line bracket-to-engine nut.
-
To install, tighten to 40 Nm (30 lb-ft).
7. Remove the power steering line clamp plate bolt, rotate the clamp plate and disconnect the power steering pressure line.
-
To install, tighten to 23 Nm (17 lb-ft).
8. To install, reverse the removal procedure.
9. Fill the power steering system.
