Expedition 2WD V8-5.4L (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the accessory drive belt from the A/C compressor pulley.
3. Disconnect the A/C compressor electrical connector.
4. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
5. Remove the 3 bolts and position the A/C compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the bolt and the CKP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
-
Lubricate the O-ring seal with clean engine oil prior to installation.