Expedition 2WD V8-5.4L (2009)
Removal and Installation
All fuel tanks
1. Remove the fuel tank.
106L (28 gal) fuel tank
2. Disconnect the fuel supply tube-to-heat shield pushpin retainer.
125L (33 gal) fuel tank
3. Remove the fuel tank heat shield retainer(s).
All fuel tanks
4. Remove the fuel tank heat shield.
5. Disconnect the Fuel Tank Pressure (FTP) sensor and vapor tube assembly-to-fuel vapor/grade vent valves quick connect couplings.
6. Disconnect the FTP sensor and vapor tube assembly-to-fuel pump module quick connect coupling.
7. Remove the FTP sensor and vapor tube assembly from the fuel tank.
8. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Emission Control Systems/Evaporative Emissions System/Testing and Inspection.