Expedition 2WD V8-5.4L (2009)
-
Disconnect: Battery Junction Box (BJB) Fuses 35 (40A) and 75 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test A. See: Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to W6.
-------------------------------------------------
W6 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE DISABLED
-
Disconnect: BJB Fuses 52 (10A), 68 (60A) and 69 (60A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test B. See: Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to W7.
-------------------------------------------------
W7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TCM DISABLED
-
Disconnect: BJB Fuse 26 (15A) and 54 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test G. See: Pinpoint Test G: The Transmission Control Module (TCM) Does Not Respond To The Scan
Tool
No
INSTALL the removed fuses. GO to W8.
-------------------------------------------------
W8 VERIFY VEHICLE EQUIPMENT - 4X4 CONTROL MODULE
-
Inspect the vehicle for a 4X4 control module.
-
Is the vehicle equipped with a 4X4 control module?
Yes
GO to W9.
No
GO to W10.
-------------------------------------------------
W9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE 4X4 CONTROL MODULE DISABLED
-
Disconnect: BJB Fuse 20 (20A) and 27 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
