Expedition 2WD V8-5.4L (2009)
Inertia Fuel Shutoff Switch: Service and Repair
Inertia Fuel Shutoff (IFS) Switch
Removal and Installation
1. NOTE: The Inertia Fuel Shutoff (IFS) switch is located behind the LH quarter trim panel access cover.
Remove the LH quarter trim panel access cover.
2. Remove the power liftgate motor electrical connector pushpins from the power liftgate motor bracket.
3. NOTE: Slide the IFS switch out below the power liftgate motor bracket.
Remove the 2 bolts and the IFS switch.
-
To install, tighten to 2 Nm (18 lb-in).
4. Disconnect the IFS switch electrical connector.
5. To install, reverse the removal procedure.