Expedition 2WD V8-5.4L (2009)
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Control
Module (ACM) Self-Diagnostic Mode See: Procedures/Audio Control Module (ACM) Self-Diagnostic Mode.
1. NOTE: Module configuration is required when a new ACM is being installed.
Upload the ACM configuration information to the scan tool.
2. Remove the instrument panel center finish panel.
3. Remove the 4 screws and the ACM.
-
Disconnect the electrical connectors and the antenna cable connector.
4. To install, reverse the removal procedure.
-
Download the configuration information to the ACM.
Accessory Protocol Interface Module (APIM)
Accessory Protocol Interface Module (APIM)
