Expedition 2WD V8-5.4L (2009)
Power Trunk / Liftgate Control Module: Service and Repair
Liftgate/Trunk Module (LTM)
Liftgate/Trunk Module (LTM)
Removal and Installation
1. Remove the rear quarter trim panel.
2. Remove the Liftgate/Trunk Module (LTM).
1. Disconnect the electrical connectors.
2. Remove the bolt.
-
To install, tighten to 9 Nm (80 lb-in).
3. To install, reverse the removal procedure.
-
Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization See: Body and Frame/Doors, Hood and
Trunk/Trunk / Liftgate/Service and Repair/Procedures.