Expedition 2WD V8-5.4L (2009)
Interface Module (APIM) must be configured correctly to fully support 911 assist functionality.
1. When installing a new RCM, carry out the appropriate steps necessary for the PMI procedure.
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering. See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint
System (SRS) Depowering and Repowering
Vehicles with center console
3. Remove the center console.
Vehicles with bucket seats without center console
4. Position the carpet aside and remove the 3 RCM pushnut retainers and the RCM cover.
All vehicles
5. Disconnect the small RCM electrical connector.
1. Push down to release the retaining tab.
2. While releasing the retaining tab, pull out and disconnect the small RCM electrical connector.
6. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever away from the RCM, disengaging the lever.
2. Pull out and disconnect the large RCM electrical connector.
7. Remove the 3 bolts and RCM.
Installation
All vehicles
1. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Install the RCM and 3 bolts.
-
Tighten to 11 Nm (97 lb-in).
2. Make sure the connector position assurance lever is in the full release position before attempting to connect the connector.
