Expedition 2WD V8-5.4L (2009)
11. Disconnect the 2 driver air bag module electrical connectors, horn switch connector and remove the driver air bag module.
12. Turn the steering wheel so the top of the wheel is back in the straight ahead 12 o'clock position.
Installation
1. Connect the horn switch connector and 2 driver air bag module connectors.
2. Position the driver air bag module to the steering wheel lining up the locator pins.
3. NOTE: For correct installation, make sure all 3 driver air bag module wire clips are fully engaged and seated correctly to the steering wheel.
Firmly press the driver air bag module to the steering wheel, seating the 3 driver air bag module wire clips to the steering wheel hooks.
-
Check the driver air bag module trim cover to the steering wheel for an even gap clearance and correct movement.
4. Install the steering column lower shroud.
-
If equipped, connect the power tilt steering column switch located on the lower shroud.
5. Install the steering column upper shroud.
6. Install the 3 steering column lower shroud screws.
7. If equipped, install the steering column manual tilt lever and screw.
-
Tighten to 6 Nm (53 lb-in).
