ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Clockspring Assembly / Spiral Cable, Air Bag > < Air Bag Control Module|Locations|Page 6113
Page 4
background image

All vehicles

8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  See: Air Bag(s)

Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.

9. If a new RCM was installed, carry out the appropriate steps in the Programmable Module Installation (PMI) procedure.  See: Powertrain

Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning

10. Prove out the SRS as follows:

Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag warning
indicator with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF.
If an air bag SRS fault is present, the air bag warning indicator will:

-

fail to light.

-

remain lit continuously.

-

flash.

The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.

Clear all continuous memory DTCs from the RCM.

Clockspring Assembly / Spiral Cable, Air Bag > < Air Bag Control Module|Locations|Page 6113