Expedition 2WD V8-5.4L (2009)
Seat Belt Reminder Lamp: Service and Repair
Belt-Minder(R) Deactivating/Activating
Preparation
1. Set the parking brake.
2. Place the transmission in PARK (P).
3. Turn the ignition switch to the OFF position.
4. Close all the vehicle doors.
5. Unbuckle the driver and passenger safety belts.
Deactivating/Activating
1. Turn the ignition switch to the RUN position (do not start the engine).
2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off or the procedure must be repeated.
Buckle then unbuckle the safety belt 9 times, ending with the safety belt unbuckled.
4. NOTE: After Step 3, the safety belt warning indicator lamp illuminates for 3 seconds.
Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
-
This disables the Belt-Minder(R) feature if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second
for 3 seconds.
-
This enables the Belt-Minder(R) feature if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second
for 3 seconds followed by a second series of 4 flashes per second for 3 seconds.
5. After confirmation, the deactivation/activation procedure is complete.
