Expedition 2WD V8-5.4L (2009)
Open the D-ring cover and remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
Third row retractors
4. NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover and bolt. Expedition
and Navigator third row D-ring cover is serviced as part of the safety belt retractor assembly.
If equipped, open the D-ring cover and remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
5. If equipped, remove the sling bolt cover and safety belt sling bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
6. For RH third row safety belt retractor, remove the 2 screws and position aside the auxiliary relay box, if equipped.
All retractors
7. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
8. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
NOTE: Before installing the third row safety belt anchor, make sure the floor-slotted plastic insert is still present. If it is not, another insert must
be installed.
To install, reverse the removal procedure.
9. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Safety Belt System
See: Testing and Inspection/Component Tests and General Diagnostics.
