Expedition 2WD V8-5.4L (2009)
LABOR ALLOWANCES
PARTS REQUIREMENTS / ORDERING INFORMATION
Parts are not required to complete this repair.
Attachment III - Technical Information
OVERVIEW
This program involves adjustment of the brake stoplamp switch by removing and reinstalling it.
SERVICE PROCEDURE
NOTICE:
It is very important to not press, pull or touch the brake pedal assembly during the installation of the brake stoplamp switch. Failure to follow these
instructions may damage the brake stoplamp switch.
1. Disconnect the brake stoplamp switch electrical connector.
2. NOTE: The stoplamp switch will be difficult to remove if the switch plunger is not depressed. A slight rearward force should be adequate to depress
the plunger.
With a light force (approximately 1-4 Pounds [4-16 Newtons]), pull rearward on the brake pedal, rotate the brake stoplamp switch 45 degrees
clockwise and remove the brake stoplamp switch.
3. Without movement to the brake pedal assembly, install the brake stoplamp switch and rotate 45 degrees counterclockwise.
4. Connect the brake stoplamp switch electrical connector.