Expedition 2WD V8-5.4L (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Removal and Installation
LH Camshaft Position (CMP) sensor
1. Remove the Air Cleaner (ACL) outlet pipe.
All CMP sensors
2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
3. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
-
Lubricate the O-ring seal with clean engine oil prior to installation.
4. To install, reverse the removal procedure.