Expedition 2WD V8-5.4L (2009)
1. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley See: Power Steering Pump Pulley.
2. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
3. Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose.
4. Remove the power steering pressure line bracket-to-engine nut.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Disconnect the power steering pressure line-to-power steering pump fitting.
-
Discard the Teflon(R) seal.
-
To install, tighten to 65 Nm (48 lb-ft).
6. Remove the 3 bolts and the power steering pump.
-
To install, tighten to 25 Nm (18 lb-ft).
7. To install, reverse the removal procedure.
-
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal on the pressure line-to-pump fitting.
8. Fill the power steering system.
