Expedition 2WD V8-5.4L (2009)
5. Release the lower cooling fan shroud tab and rotate the shroud upwards.
6. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the power steering pump pulley.
7. Position the cooling fan shroud assembly upward to gain clearance to install the Power Steering Pump Pulley Remover.
8. Using the Power Steering Pump Pulley Remover, remove the power steering pump pulley.
Installation
1. NOTE: If the pulley has been removed and installed twice, install a new power steering pump pulley.
NOTE: Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is 1 paint mark or
none at all, use a paint pencil to mark the web area of the pulley near the hub.
Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.
2. Rotate the accessory drive belt tensioner clockwise and install the accessory drive belt to the power steering pump pulley.
3. Lower the cooling fan shroud assembly.
-
Release the lower cooling fan shroud tab, rotate the shroud downward.
