Expedition 2WD V8-5.4L (2009)
28. Remove the cover and the LH C-pillar trim panel nut.
29. Release the rear door weatherstrip and remove the driver C-pillar trim panel.
30. Disconnect the LH safety canopy module electrical connector.
31. NOTE: There are 2 similar connectors under the driver seat. The driver seat side air bag module electrical connector is located toward the seat
outboard position.
Remove the driver front seat cushion panel shield and disconnect the driver seat side air bag module electrical connector.
32. Install the RCM fuse 32 (10A) to the Smart Junction Box (SJB).
33. Connect the battery ground cable.
Reactivation
1. Remove the RCM fuse 32 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Connect the driver seat side air bag module electrical connector and install the driver front seat cushion panel shield.
