Expedition 2WD V8-5.4L (2009)
15. Connect the passenger air bag module electrical connector.
16. Close the glove compartment door.
-
If equipped, connect the glove compartment door dampener.
17. NOTICE: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match
the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag
module. Damage to the connector or component may occur.
Connect the horn switch and 2 driver air bag module electrical connectors.
18. Position the driver air bag module to the steering wheel, lining up the locator pins.
19. NOTE: Make sure that all 3 driver air bag module wire clips are fully engaged and seated correctly to the steering wheel.
NOTE: Audible clicks will be heard when the 3 driver air bag module wire clips are fully engaged.
Firmly press the driver air bag module to the steering wheel, seating the 3 driver air bag module wire clips to the steering wheel hooks.
-
Check the driver air bag module trim cover to the steering wheel for an even gap clearance and correct movement.
20. Install the steering column lower shroud.
-
If equipped, connect the power tilt steering column switch located on the lower shroud.
21. Install the steering column upper shroud.
22. Install the 3 steering column lower shroud screws.
23. If equipped, install the steering column manual tilt lever and screw.
-
Tighten to 6 Nm (53 lb-in).
24. If equipped, connect the adjustable pedals switch connector.
