Expedition 2WD V8-5.4L (2009)
Tilt Wheel Motor: Service and Repair
Steering Column Motor
Removal and Installation
1. Remove the steering column. For additional information, refer to Steering Column See: Service and Repair/Removal and Replacement/Steering
Column.
2. Remove the screw and the ignition switch.
-
To install, tighten to 5 Nm (44 lb-in).
3. Remove the roll pin from the steering column motor.
4. Remove the bolt and the motor.
-
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
