Expedition 2WD V8-5.4L (2009)
-
To install, tighten the new bolt to 30 Nm (22 lb-ft).
4. Remove the bolt and disconnect the upper steering column shaft from the lower steering column shaft.
-
Discard the bolt.
-
To install, tighten the new bolt to 48 Nm (35 lb-ft).
5. Remove the 2 bolts, the dash seal and the upper steering column shaft.
-
To install, tighten to 12 Nm (106 lb-in).
6. Remove the bolt and disconnect the lower steering column shaft from the steering gear.
-
Discard the bolt.
-
To install, tighten the new bolt to 30 Nm (22 lb-ft).
7. WARNING: Do not reuse steering column shaft bolts. This may result in fastener failure and steering column shaft detachment or loss of
steering control. Failure to follow this instruction may result in serious injury to vehicle occupant(s).
To install, reverse the removal procedure.
