Expedition 2WD V8-5.4L (2009)
3. Using the C-Frame and Screw Installer/Remover and the Ball Joint Installer/Remover, remove the ball joint.
Installation
1. NOTICE: Do not damage the ball joint boot when installing the special tool.
NOTE: Clean and inspect the ball joint bore for bore damage before installing a new ball joint.
Using the C-Frame and Screw Installer/Remover and the Ball Joint Installer/Remover, install the ball joint.
2. NOTE: Always use a new ball joint snap ring.
Install a new snap ring.
3. Install the wheel knuckle. For additional information, refer to Wheel Knuckle See: Rear Knuckle/Service and Repair/Wheel Knuckle.