ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Cross-Member|Service and Repair|Page 5480 > < Cross-Member|Service and Repair
Page 2
background image

4. Remove the 2 transmission mount nuts.

-

To install, tighten to 103 Nm (76 lb-ft).

5. Support the transmission.

6. NOTE:

-

Mark the transmission crossmember next to the edge of the frame bracket to make sure the crossmember is installed in the same position it was
removed from.

-

The crossmember nuts are installed on the crossmember bolts facing the front of the vehicle.

Remove the 4 transmission crossmember bolts (2 each side) and the transmission crossmember.
-

To install, tighten to 90 Nm (66 lb-ft).

Cross-Member|Service and Repair|Page 5480 > < Cross-Member|Service and Repair