Expedition 2WD V8-5.4L (2009)
6. NOTE: After installing the wheel knuckle bushing, make sure to measure the bushing position in the wheel knuckle bore. The measurement from
the bushings outer metal surface to the machined face surface of knuckle bore should be 2.54 mm (0.16 in) +/- 0.25 mm (0.01 in).
If necessary, use the Bearings and Washers Forcing Screw, the Bushing Remover and the Bushing Remover/Installer to adjust the bushing position
in the wheel knuckle bushing bore.
7. NOTE: Do not tighten the trailing arm-to-wheel knuckle bolt at this time.
Connect the upper trailing arm-to-the wheel knuckle and loosely install the bolt.
8. Install the wheel and tire.
9. Lower the vehicle so that the weight of the vehicle is resting on the wheel and tires.
10. Tighten the new upper trailing arm-to-the wheel knuckle bolt to 250 Nm (184 lb-ft).
