Expedition 2WD V8-5.4L (2009)
1. Compress the IWE and install a vacuum cap on the vacuum port.
2. NOTICE: Do not dislodge the Integrated Wheel End (IWE) seal spring when installing the IWE on halfshaft outboard end or component
damage may occur.
Install the IWE onto the halfshaft outboard end.
3. NOTE: Allow the wheel knuckle to swing outward while keeping the halfshaft pushed inward.
Once clearance is available, install the halfshaft outboard end into the wheel knuckle hub bearing.
4. Connect the upper ball joint and install a new nut.
-
Tighten to 115 Nm (85 lb-ft).
5. Connect the tie rod and install a new nut.
-
Tighten to 115 Nm (85 lb-ft).
6. Position the front brake flexible hose bracket and install the bolt.
-
Tighten to 12 Nm (106 lb-in).
7. Position the wheel speed sensor harness bracket and install the bolt.
-
Tighten to 12 Nm (106 lb-in).
8. Install the 3 IWE-to-wheel knuckle retaining bolts.
-
Tighten to 12 Nm (106 lb-in).
9. Remove the IWE vacuum cap and connect the vacuum tubes.
10. NOTICE: Verify the spline engagement by checking for spline lash before installing the axle nut or component damage may occur.
Install the new axle nut.
-
Tighten to 27 Nm (20 lb-ft).
11. Install the dust cap.
12. Install the front wheel and tire.
