Expedition 2WD V8-5.4L (2009)
6. NOTE: Before installing the mechatronic assembly into the transmission case, verify presence and correct orientation of the thermal bypass valve,
pump adapter seal and center support seals. Also note that one or more of the center support seals may have remained in the mechatronic assembly
during removal and should be installed into the transmission case at this time.
Verify the 4 rubber feed tubes for the center support are in place.
1. Black feed tubes
2. Green feed tube
3. Blue feed tube
7. Verify the rubber adapter is in place.
8. Coat the thermal bypass valve with petroleum jelly to hold it in place and install the thermal bypass valve in the transmission case.
9. NOTICE: Do not touch the electrical connector pins or the exposed solenoid tabs on the transmission vehicle harness connector.
Electrostatic discharge may occur and may cause damage to the mechatronic unit.
Position the mechatronic assembly in place and loosely install the 11 bolts.
1. Align the manual valve and control lever linkage.
