Expedition 2WD V8-5.4L (2009)
Shift Interlock Solenoid: Service and Repair
Brake Shift Interlock Actuator - Column Shift
Brake Shift Interlock Actuator - Column Shift
Removal and Installation
1. Apply the park brake.
2. Remove the lower and upper steering column shrouds.
3. Turn the ignition switch to the accessory position and apply the brake or actuate the Brake Shift Interlock Actuator (BSIA) override.
4. Put the selector lever into the NEUTRAL position.
5. Disconnect the BSIA electrical connector.
6. Remove the BSIA screw.
7. Gently pry the clip up and remove the BSIA.
8. NOTE: When installing the BSIA, verify that the BSIA override has been activated and the slider is fully rearward. Before rotating the selector
lever from NEUTRAL into PARK, align the selector lever tab into the BSIA.
To install, reverse the removal procedure.
