Expedition 2WD V8-5.4L (2009)
2. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make
sure that the selector lever is locked into the selector lever cable bracket.
Install the selector lever cable into the selector lever cable bracket.
3. NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control lever
ball stud. Pull back on the selector lever cable to make sure that the selector cable end is correctly installed onto the manual control lever ball stud.
Connect the selector lever cable onto the manual control lever ball stud.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is correctly installed.
4. Lock the selector lever cable lock tab.
5. NOTE: Install a new heat shield if it is loose on the cable.
If equipped, install the heat shield.