Expedition 2WD V8-5.4L (2009)
6. Reposition the air deflector and install the pushpin.
7. Position the sway bar in place and install 4 new sway bar bracket nuts.
-
Tighten to 55 Nm (41 lb-ft).
8. NOTICE: Only use hand tools when installing the engine mount nuts or damage to the engine mount may occur.
For 4WD vehicles, lower the engine and install the RH engine mount nuts.
-
Tighten to 175 Nm (129 lb-ft).
9. NOTE: Inspect the case to make sure that the old transmission fluid cooler tube O-rings are not stuck in the case.
NOTE: Install new transmission fluid cooler tube O-rings on the ends of the cooler lines prior to installing.
Install new O-rings on the transmission fluid cooler tubes.
10. Position the transmission fluid cooler tubes into the transmission, then install the transmission fluid cooler tube bracket bolt.
-
Tighten to 25 Nm (18 lb-ft).
