Expedition 2WD V8-5.4L (2009)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft - Front
Driveshaft - Front
Removal and Installation
1. With the vehicle in NEUTRAL, position the vehicle on a hoist.
2. Index-mark the front flange to the pinion flange.
3. Index-mark the rear flange to the transfer case flange.
4. Remove and discard the 6 rear flange-to-transfer case flange bolts and 3 washers.
-
To install, tighten to 55 Nm (41 lb-ft).