Expedition 2WD V8-5.4L (2009)
6. NOTE: Align the original index-marks at the transfer case. Do not rotate the driveshaft when removing the slip yoke from the transfer case output
shaft.
Remove the driveshaft.
-
Mark the transfer case output shaft to the transfer case housing after removing the driveshaft.
Rear Wheel Drive (RWD) vehicles
7. Index-mark the driveshaft flanges for correct alignment during installation.
8. Remove and discard the 4 driveshaft front flange bolts.
9. Remove and discard the 4 driveshaft rear flange bolts.
10. NOTICE: The driveshaft flange fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the driveshaft from the pinion flange. Pry only in the area shown, with a suitable tool, to disconnect the driveshaft flange from
the pinion flange or damage to the component may occur.
Using a suitable tool, disconnect the driveshaft flange from the pinion flange.
11. Remove the 2 driveshaft center bearing bolts, then remove the driveshaft.
-
Discard the driveshaft center bearing bolts.
