Expedition 2WD V8-5.4L (2009)
12. Remove the outboard boot.
13. NOTE: If the grease is contaminated, clean and inspect the joint for wear. Install a new outboard CV joint and interconnecting shaft assembly if
worn/damaged.
Check the grease for contamination.
Assembly
1. Position the outboard boot on the shaft.
2. Pack the outboard CV joint with 175 g (6.17 oz) of grease.
1. Use CV joint grease or equivalent provided in the boot kit.
2. Spread any remaining grease from the kit evenly inside the boot.
3. Install the outboard boot.
1. Clean the boot mounting surface.
2. Seat the boot in the joint boot groove.
