Expedition 2WD V8-5.4L (2009)
Front Door Window Regulator: Service and Repair
Window Regulator - Front Door
Window Regulator - Front Door
Removal and Installation
NOTE: The power window regulator motor must be re-initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the
vehicle. For additional information, refer to Window Motor Initialization See: Service and Repair.
1. Remove the front door trim panel.
2. NOTE: There are 2 tabs on the opposite side not shown in the illustration.
Unlock the 4 tabs and remove the window control switch from the door trim panel.
3. Remove the screws and the front door speaker.
-
Disconnect the electrical connector.
4. Remove the front door weathershield.
5. Re-connect the electrical connectors to the window control switch.
6. Lower the window glass to access the 2 window glass clamp bolts.
7. Loosen the window glass clamp bolts.
-
To install, raise the window glass until it stalls in the UP position. Tighten the window glass clamp bolts to 11 Nm (97 lb-in).
8. NOTE: Secure the front window glass in the full UP position.
Secure the front window glass with tape to the front door frame.
