Expedition 2WD V8-5.4L SOHC VIN L (1997)
wrong position, the LEDs on the TR cable will give false or no response during testing resulting in the replacement of good parts.
1. Place transmission range selector lever into PARK.
2. Make sure that the E cable ANALOG/DIGITAL switch is set to DIGITAL.
3. Move the transmission range selector lever through all ranges.
4. Monitor the LEDs, located on the E cable, in each gear position. The LED should illuminate RED for the appropriate range selected.
5. If the LED for the applicable gear range position fails to illuminate RED or if it lights for a position other than the gear selected perform the
following:
-
Verify test cable connections at sensor and tester.
-
Verify transmission shift linkage for proper adjustment.
-
Verify TR sensor for proper adjustment.
-
Retest.
6. If the sensor still fails to illuminate the LED RED for the selected gear range or indicates incorrect gear position, replace it.
SWITCH TEST - PARK/NEUTRAL, BACKUP LAMP AND OPTIONAL CIRCUITS
1. Turn the tester selector switch to the DIGITAL TR SENSOR TEST position.
2. Press and hold each button while moving the transmission range selector lever through each gear position.
3. Monitor each LED.
4. The status LED should indicate RED only in the indicated position. Refer to the overlay.
NOTE: The LED will turn RED when the circuit closes and turn off when the circuit is open.
5. If the LED does NOT indicate RED in the desired position, or indicates RED in another position, first verify transmission range (TR) sensor
alignment and then retest. If the sensor fails, replace it.
DISCONNECTING THE TESTER
1. Disconnect the transmission tester from the transmission range (TR) sensor connector.
CAUTION: Do not attempt to pry off connectors with a screwdriver. This will damage the connector and could result in a transmission concern.
2. Reinstall the vehicle wiring harness. Verify the connection by pulling up on the harness.
3. Disconnect the transmission tester power lead from vehicle.
4. Erase all DTCs.
5. Rerun the on-board diagnostic tests to receive a pass code.
6. Verify that the customer concern has been eliminated.