Expedition 4WD V8-281 4.6L SOHC (1998)
Pressure Regulating Solenoid: Service and Repair
REMOVAL
1. Remove the manual control lever.
2. CAUTION: Do not pull on the plastic lead frame. This may cause damage to the connector ends. Carefully pry up on locking tabs to disconnect
the sensors.
Disconnect the molded lead frame from the sensors.
1
Disconnect the shift solenoid SSA/SS1 and SSB/SS2.
2
Disconnect the Torque Converter Clutch (TCC).
3
Disconnect the Electronic Pressure Control (EPC) solenoid.
4
Disconnect the bulkhead inter connector.
3. Remove the EPC solenoid.
INSTALLATION