Expedition 4WD V8-4.6L SOHC VIN W (1999)
Transmission Mount: Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Raise the vehicle on a hoist.
3. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
Remove the rear driveshaft.
1
Remove the four bolts.
2
Remove the driveshaft.
4. Use High-Lift Jack to support the transmission.
5. Remove the nuts.
6. Remove the bolts.