Expedition 4WD V8-5.4L VIN 5 (2006)
3. Remove the RH A-pillar lower trim panel.
4. Disconnect the rear antenna lead-in cable from the front antenna lead-in cable.
5. NOTE: The antenna is an integral part of the wiring harness and cannot be replaced separately from the harness. Cut the ends off of the old
antenna cable and tape the remainder to the wiring harness to prevent noise.
Remove the ground plate and remove the antenna cable ends.
6. NOTE: When installing the new cable, tape or wire-tie the new cable to the wiring harness to prevent noise.
To install, reverse the removal procedure.
