Expedition 4WD V8-5.4L VIN 5 (2006)
2. Disconnect the anti-lock brake system (ABS) module electrical connector.
3. CAUTION: Only authorized inlet hydraulic brake tubes should be used. These tubes are of specific design and only authorized parts should be
used when installing new inlet brake tubes.
NOTE: Plug each open port to prevent brake fluid from spilling.
Disconnect the 6 brake tube fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
4. Remove the 3 hydraulic control unit (HCU)-to-bracket bolts and the HCU.
^
To install, tighten to 9 Nm (80 inch lbs.).
5. To install, reverse the removal procedure.
^
Bleed the brake system.