Expedition 4WD V8-5.4L VIN 5 (2006)
Remove the stoplight switch self-lock pin cover, the pin and slide the stoplight switch, booster push rod and the bushing off the brake pedal pin.
4. NOTE: Do not apply the brake pedal during the removal or installation of the speed control deactivation switch.
Disconnect the electrical connector and turn the speed control deactivator switch counterclockwise to detach it from the brake pedal bracket.
5. Remove the bulkhead sound insulator.
6. Remove the 4 brake pedal bracket nuts.
^
To install, tighten to 22 Nm (16 ft. lbs.).
7. Remove the brake pedal bracket bolts and remove the brake pedal and bracket.
^
To install, tighten to 22 Nm (16 ft. lbs.).
8. To install, reverse the removal procedure.