Expedition 4WD V8-5.4L VIN 5 (2006)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator and Tube
Material
Removal and Installation
1. With the vehicle in neutral, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the oil level indicator and tube bolt.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Remove the oil level indicator and tube from the cylinder block.
^
Discard the O-ring seal.
4. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
To install, reverse the removal procedure.
^
Install a new O-ring seal.