Expedition 4WD V8-5.4L VIN 5 (2006)
4. Rotate the belt tensioner clockwise and disconnect the accessory drive belt from the coolant pump pulley.
5. Remove the 4 bolts and the coolant pump pulley.
6. Remove the 4 bolts and the coolant pump.
^
Discard the O-ring seal.
^
To install, tighten to 25 Nm (18 ft. lbs.).
7. To install, reverse the removal procedure.
^
Inspect the mating surfaces. Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging.
^
Install a new O-ring seal. Lubricate the O-ring seal with clean engine coolant prior to installation.