Expedition 4WD V8-5.4L VIN 5 (2006)
Removal and Installation
1. Remove the bolts and position the accelerator pedal aside.
-
To install, tighten to 25 Nm (18 lb-ft).
2. Disconnect the floor/defrost door vacuum control motor vacuum connector.
3. Remove the 2 floor/defrost door vacuum control motor screws.
4. Rotate the floor/defrost door vacuum control motor until it clears the retaining arm and remove.
5. To install, reverse the removal procedure.
Panel Door
VACUUM CONTROL MOTOR - PANEL DOOR
Removal and Installation
1. Remove the instrument panel. Refer to: Body and Frame, Interior Moulding/Trim, Dashboard/Instrument Panel, Service and Repair, Instrument
Panel, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel
2. Disconnect the panel door vacuum control motor vacuum connector.
3. Remove the 2 panel door vacuum control motor screws.
4. Rotate the panel door vacuum control motor until it clears the retaining arm and remove.
5. To install, reverse the removal procedure.