Expedition 4WD V8-5.4L VIN 5 (2006)
3. Remove the glove compartment.
4. Disconnect the 3 electrical connectors.
5. Remove the 2 screws and the vehicle security module.
Installation
1. Position the vehicle security module and install the 2 screws.
-
Tighten the screws to 6 Nm (53 lb-in).
2. Connect the 3 electrical connectors.
3. Position the RH A-pillar lower trim panel and install the pin-type retainer.
4. Install the glove compartment
5. Connect the battery.
6. NOTE: When successful, this step provides the calibration necessary for vehicle security module operation and clears DTC B2477. The clearing
of the DTC indicates the calibration data has been successfully downloaded to the vehicle security module.
Download the vehicle security module configuration information from the diagnostic tool to the vehicle security module.
7. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the vehicle security
module has recognized the tire pressure sensors during the training procedure.
Train the tire pressure sensors.
8. Clear the DTCs.
9. NOTE:
-
DTC C2780 will not clear if any other DTCs are present in the vehicle security module.
-
This step is required to clear DTC C2780, allow the vehicle security module to exit the manufacturing mode, and to be sure there are no other
concerns with the newly programmed vehicle security module.
Carry out the vehicle security module on-demand self-test.
