Expedition 4WD V8-5.4L VIN 5 (2006)
Fuel Pump Control Unit: Service and Repair
Fuel Pump Driver Module (FPDM)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. NOTE: The fuel pump driver module (FPDM) is located on the top of the LH frame rail near the fuel tank filler pipe.
Disconnect the FPDM electrical connector.
4. Remove the bolts and the FPDM.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.
