Expedition 4WD V8-5.4L VIN 5 (2006)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTE: When installing a new module, it must be calibrated and configured (either by download/upload or uploading the as-built data method).
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the anti-lock brake system (ABS) module electrical connector.
3. Remove the 3 bolts and the ABS module.
^
To install, tighten to 2 Nm (18 inch lbs.).