Expedition 4WD V8-5.4L VIN 5 (2006)
Part 2
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the nut and position the ground cable terminal aside at the starter.
-
To install, tighten to 22 Nm (16 lb-ft).
4. Remove the nut and position the starter solenoid positive cable terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
5. Remove the nut and position the starter solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
6. Disconnect the 2 battery cable harness locators from the A/C compressor mounting bolts.
7. Remove the bolt and position the battery ground cable-to-frame terminal aside.
-
To install, tighten to 30 Nm (22 lb-ft).
8. Remove the nut and position the generator harness terminal and the CJB cable terminal aside.
-
To install, tighten to 9 Nm (80 lb-in).
9. Remove the bolt and position the battery ground cable-to-cowl panel terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
10. Disconnect the battery cable harness in-line electrical connector and remove the battery cable assembly.
11. To install, reverse the removal procedure.